2004 - 2012 Chevy Colorado/GMC Canyon Front Bumper
Installation Instructions
PREPARATION
1.
Disconnect the negative terminal on the battery. Park the vehicle on level ground and set the
emergency brake.
2.
We recommend reading through the installation instructions in whole before performing the work.
3.
Estimated Installation Time:
2 Hours
4.
You will need the following tools:
a.
Ratchet
b.
Drill
c.
1/2” Drill Bit
d.
3/4” Socket & Wrench
e.
Sharpie
Note: this installation requires 2 people for best results
5.
Included in Kit:
4
–
Hex Head Bolts
–
1/2”
-
20 x 4”
8
–
Flat Washers
–
1/2”
4
–
Metal Lock Nuts
–
1/2”
-20
REMOVAL
1.
Remove the clips that hold on the OEM grille. Then, remove the grille by pulling it forward and off the
truck.
2.
Remove the four upper mounting bolts that can be seen by looking down from the top of the bumper.
3.
Remove the two lower mounting bolts (per side). These bolts can be accessed from underneath the
vehicle and are at each side of the bumper, near the fog lights.
4.
Pull the OEM bumper off the truck.
5.
Reinstall your grille by pressing it back onto the truck and reinstalling the plastic clips.
6.
Prepare to install your new ADD Front Bumper.
INSTALLATION
1.
Hold your new ADD Bumper in place on the frame rails, then mark where the mounting holes meet the
frame rails. (Fig A)
