WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer
onto your belt or the top edge of your pants or skirt. It should fit
snugly and level, above one knee.
Note:
The pedometer should be as vertical as possible. Walkers
with larger stomachs may find it helpful to wear the pedometer
farther back on the body, toward one hip.
To avoid losing or dropping your pedometer, use the included
leash and clip to fasten the pedometer securely to your clothing.
Attaching the Leash:
Attach the pedometer to the leash by
looping the leash around the pedometer belt clip. Next, clasp
the waist-band of your clothing with the attached clip. You can
also use a safety pin to fasten the leash to your clothing, loop
the leash through your belt or belt loop or use a badge holder.
OPERATING INSTRUCTIONS
ACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131
800-965-2008 • 925-226-0888 • FAX 925-463-0147 www.ACCUSPLIT.com • [email protected]
ACCUSPLIT®
EAGLE
™
1120
Eat Right! Walk More! Live Well! The ACCUSPLIT Lifestyle
Congratulations on taking the first step to wellness with your purchase of an
ACCUSPLIT pedometer. It’s easy to set up your new pedometer.
Just follow the steps below, and start walking!
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To \reset:
Press and hold RESET button for at least three seconds to
reset to zero.
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in standby
mode until 5 continuous steps are registered. Only then are
the 5 steps calculated in, and an Active indicator “
▲
”
appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the
timer pauses and the unit switches to standby status (Active
indicator “
▲
” disappears).
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to
replace the battery. Your pedometer uses one Type L1142
(LR43) 1.5 volt silver oxide battery. To replace:
1. Using a jeweler’s screwdriver, loosen small screw
on back of unit. Remove back of case.
2. Slide the old battery gently out of its holder. Replace it with
a new battery. The battery’s positive (+) terminal should be
FACE UP while you put it into the pedometer.
3. Gently press front and back of pedometer case back
together, being sure to line up slots and tabs at top and
bottom of unit.
ACCUSPLIT
AccuSTEP
10000.org
STEP
TW15MG
1 1 2 0
EAGLE
RESET
VIEWING YOUR RESULTS
Once you put on your pedometer, it will automatically begin to
record your steps.
970-042
First, loop the
pedometer clip
Next, loop the metal
clip, then clasp clothing
Or, loop a
badge holder, then
put into pocket
(Badge holder
not included)
Or, loop a belt or belt loop
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
Refurbish, repair-or-replace service before 10/1/10, $5 fee; After 10/1/10,
service may not be available. Return with fee and day phone # to:
AST Repair Center/970-1010, 2290M Ringwood Ave., San Jose, CA 95131
REGISTER NOW
Please return
your AE1120 Registration to the
Repair Center address in the
warranty, and we will let you
know about future products.
Email (preferred)
User
