![background image](http://html1.mh-extra.com/html/abb/thomas-and-betts-rh-series/thomas-and-betts-rh-series_manual_4344855001.webp)
Tel: (888) 552-6467
Fax: (800) 316-4515 www.tnb.com
02/15 750.1593 Rev. B
1/4
Pictogram Sign for Hazardous Locations
Pictogram Sign for Hazardous Locations
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
Servicing of this equipment should be performed by qualified service
personnel.
2.
Make sure the area is clear of all HAZARDS before installing or ser-
vicing the unit.
3.
Turn off electrical power before and during installation and mainte-
nance.
4.
Before conducting maintenance, turn off the unit and wait for it to
cool.
5.
Do not install where the marked operating temperatures (T-Code)
exceed the ignition temperature of the hazardous atmosphere.
6.
Do not operate in ambient temperatures above those indicated on
the rating labels.
7.
Keep tightly closed when in operation.
8.
Do not use outdoors.
9.
Do not let the power cords touch hot surfaces.
10.
Do not mount near gas or electric heaters.
11.
Use caution when handling batteries. Battery acid can cause burns to
the skin and eyes. If acid is spilled on the skin or eyes, flush acid
with fresh water and contact a physician immediatly. Avoid possible
shorting.
12.
Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
13.
The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
14.
Do not use this equipment for other than intended use.
15.
Unit to be installed only as per configuration described in this instruc-
tion manual.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
WARNING:
Risk of Shock.
Disconnect Power before Installation.
Figure 1
*
*
Part List
1.
Tamper-proof screws
2.
Tamper-proof screws with
o-ring
3.
Lens
4.
Pictogram panels
5.
Opal diffuser
6.
Frame
7.
Frame insert
8.
Frame insert mounting
screws
9.
Backplate (single face sign)
10. Backplate tamper-proof
screws
11. Lock-nuts
12. Junction box gasket
13. Junction box screws
14. junction box Cover
15. Nipple
16. Juction box
17. Hub
Figure 2
*Note: Install o-rings on the screws between the lens and the frame
.