![background image](http://html1.mh-extra.com/html/a-tach-mounts/50321/50321_quick-start-manual_3104101001.webp)
A-Tach # 50321
Designed for:
Acura TLX 2021 - 20__
ST-1
A
-Tach
Mounts
NOTICE:
A-Tach Mounts
will not be responsible for
any damage to the vehicle or product due to the
installation and/or use of the product. The product has
been tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible to determine if you have the
skill to attach the product without causing damage
to your vehicle or the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash
BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed
BEFORE
a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
forward / lower edge of the mount will attach into
the seam between the two panels on the side of the
center console illustrated with the arrow in the
photo. The tab on the mount will go into an unseen
opening in the seam that is about 1.5 inches up
from the bottom of the seam.
(2) The upper right edge of the mount will attach
into the seam between the console side panels and
the hard plastic panel on the left center console
illustrated with the arrow in the photo.
See additional instructions on the back side.