Row Power 25
4ms Company
Eurorack Power Module
User Manual 1.0 – Sept. 24, 2019
The
Row Power 25
is a power supply module for the Eurorack modular system. It
requires a barrel-style power brick (15V – 20V DC) and supplies power to modules
via flying bus cables, direction connection, and/or bus boards using the single
standard 16-pin Eurorack header on the back. For custom power systems, the
Row Power 25
has a set of easily soldered holes for using large gauge wire or
MTA156 connectors to connect to distribution bus boards.
Multiple
Row Power
modules can be powered from a single power brick by
daisy-chaining with an inexpensive barrel cable. The
Row Power 25
can also be
daisy-chained to 4ms Company’s Pod enclosures.
Maximum and recommended power output:
•
+12V: 1.4A maximum, 1.0A recommended
•
-12V: 0.8A maximum, 0.5A recommended
•
+5V: 1.0A maximum, 0.8A recommended
Maximum power output can be expected under normal operating conditions.
Recommended power output is guaranteed under extreme temperature and limited airflow
conditions.
Power Brick:
•
Available wherever
Row Power
modules are sold.
•
You may use your own power brick if it meets the following:
•
15VDC to 20VDC
•
Minimum 30W output power
•
Positive center 2.1mm barrel plug
•
Low-noise output
Features:
•
Two identical barrel power jacks at top and bottom for daisy-chaining (either
jack can be used for power input or chaining)
•
On/off switch
•
LED ind/-12V rails are functioning
•
25.6mm (1.01”) deep with power cable attached
•
22.0mm (0.87”) with no power cable (when using solder points)
•
4HP
Page of
1
4
Summary of Contents for Row Power 25
Page 4: ...Page of 4 4 ...
