background image

Scotch-Weld

Hot Melt 

Applicator AE II LT

Scotch-Weld Hot Melt Applicator AE II LT
operation and maintenance.

WARNING

To reduce the risk of 

electrical shock or injury

while 

operating or servicing the Scotch-Weld Hot Melt Applicator
AE II, observe the following safety rules:

1. Operate the applicator only as described in this manual.
2. Use only 3-pronged grounded plug and properly grounded

outlet. Failure to use properly grounded plug and outlet 

may cause electrical shock

. If you are not sure of proper

connections, get help from a qualified electrician or 
service person.

3. Do not unplug the applicator by pulling on the cord. 

Grasp the plug, not the cord, to unplug.

4. Do not handle the plug or applicator with wet hands.

5. Do not use the applicator outdoors or on wet surfaces.

6. Do not use the applicator with a damaged cord or plug.

7. Do not use the applicator if it is not working properly or has

been dropped, damaged, submerged in water or left outdoors.

8. Do not use an unapproved extension cord with the applicator.

Use of an unapproved extension cord 

may cause electrical

shock.

Use an extension cord that complies with NEC 

requirements and state and local codes and 
other requirements.

9. Do not attempt to service this applicator. It is not 

designed for servicing and attempting to do so may cause 
electrical shock.

1. Do not touch hot adhesive, applicator tip or metal 

components. 

May cause burns.

Wear heat resistant gloves 

and safety glasses.

2. Do not pull adhesive cartridge from the rear of the 

applicator while in operation. Removing adhesive from 
the rear may cause molten adhesive to flow out the rear 
of the applicator which 

may cause burns and damage 

the applicator.

Caution

Intended Use

The 3M Scotch-Weld Hot Melt Applicator AE II LT is
designed for use with 3M™ Scotch-Weld™ Hot Melt
LM AE Adhesive Sticks in an industrial environment.
Using the applicator with any other adhesive or for any
purpose other than for which it is intended is not rec-
ommended and could cause unsafe conditions.

Set up and 
Installation Procedures

Remove 

3M Scotch-Weld Hot Melt Applicator AE II and

bench stand from shipper and inspect for obvious damage.

FOR INDUSTRIAL OR PROFESSIONAL USE ONLY

• Save these instructions

• Read all instructions before using this product

1. Attach one or both of the supplied bench stands.

The small stand snaps into the two holes located on the 
front of the applicator housing.
The large wire platform stand slides into the base.

ALWAYS USE A BENCH STAND WITH 
YOUR APPLICATOR.

Important 
Safety Instructions

FOR INDUSTRIAL OR PROFESSIONAL USE ONLY

Use only 3M Scotch-Weld Hot Melt LM AE Adhesive Sticks.
Note:

For health and safety information, see product label 

and Material Safety Data Sheet for 3M Scotch-Weld Hot Melt
adhesives before using.

Indicates
high voltage

Indicates
hot surface

Reviews: