LIGHTFALLS by 3M™ + Todd Bracher Installation Guide - Sconce, Rev. C, Feb. 2014
Installation Guide LIGHTFALLS by 3M™ + Todd Bracher
Sconce
Sconce
(LF1-XX-XX-XX; All Finishes)
Application
Lightfalls by 3M™ + Todd Bracher (the “Product”) is a decorative LED lighting system for dry, interior use.
Safety Information
Please read, understand and follow all safety information contained in this Installation Guide prior to the installation of these kits. Retain these instructions
at the installation site for future reference.
To reduce risk associated with fire or electrical shock hazards:
• Electrical installation must be performed by a licensed electrician in accordance with NFPA and state or local electrical codes.
• Disconnect the power source before installing or servicing.
To reduce risk associated with fire:
• Only use the LED driver(s) provided by 3M.
To reduce risk associated with physical injury from the Product falling:
• The Lightfalls fixture can weigh up to 1 pounds/0.5 kilograms. Ensure that mounting brackets are adequately fastened to the load bearing point and
able to carry the required load. Always refer installation to a licensed electrician or certified lighting contractor.
• DO NOT use the Product if it has incurred any physical damage. Refer to a licensed electrician to check the Product before putting it into service.
!
WARNING
To reduce risk associated with associated with environmental contamination:
• At the end of product life, dispose of electronic waste in accordance with applicable local and government regulations.
To reduce the risk associated with hot surface:
• Do not attempt to access and to touch the light fixture heat sink when it is operating.
!
CAUTION
EXPLANATION OF SIGNAL WORD CONSEQUENCES
WARNING:
Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury and/or property damage.
CAUTION:
Indicates a potentially hazardous situation, which, if not avoided, could result in minor or moderate injury and/or property damage.
!
!
