ZyXEL Communications ZyXEL ZyWALL P1, User Manual

Page: 255 / 369

ZyWALL P1 User’s Guide
254 Chapter 17 Firmware and Configuration File Maintenance
5 Enter “bin” to set transfer mode to binary.
6 Find the “rom” file (on your computer) that you want to restore to your ZyWALL.
7 Use “put” to transfer files from the ZyWALL to the computer, for example, “put
config.rom rom-0” transfers the configuration file “config.rom” on your computer to the
ZyWALL. See earlier in this chapter for more information on filename conventions.
8 Enter “quit” to exit the ftp prompt. The ZyWALL will automatically restart after a
successful restore process.
17.4.2 Restore Using FTP Session Example
Figure 136 Restore Using FTP Session Example
Refer to Section 17.3.3 on page 251 to read about configurations that disallow TFTP and FTP
over WAN.
17.5 Uploading Firmware and Configuration Files
This section shows you how to upload firmware and configuration files. You can upload
configuration files by following the procedure in
Section 17.4 on page 253 . .
Note: WARNING! Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR ZyWALL.
17.5.1 Firmware File Upload
FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client.
17.5.2 FTP File Upload Command from the Command Prompt Example
Follow the steps below to upload the firmware.
1
Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your ZyWALL.
3
Press
[ENTER]
when prompted for a username.
4 Enter your password as requested (the default is “1234”).
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit