ZyXEL Communications ZyWALL USG Series, Reference Manual

Page: 367 / 426

Chapter 55 Reports and Reboot
ZyWALL / USG (ZLD) CLI Reference Guide
367
55.2 Email Daily Report Commands
The following table identifies the values used in some of these commands. Other input values are
discussed with the corresponding commands.
Use these commands to have the ZyWALL / USG e-mail you system statistics every day. You must
use the
configure terminal
command to enter the configuration mode before you can use
these commands.
show report packet size statistics
{ interface_name } [interval interval ]
Displays the specified interface’s packet size distribution statistics. You
can also specify the packet size interval into which to group the
statistics.
interval
: 128, 256, or 512 (bytes)
report packet size statistics clear
Clears the packet size statistics data for all interface.
Table 223
Packet Size Statistics Commands (continued)
COMMAND DESCRIPTION
Table 224
Input Values for Email Daily Report Commands
LABEL DESCRIPTION
e_mail
An e-mail address. You can use up to 80 alphanumeric characters, underscores (_),
periods (.), or dashes (-), and you must use the @ character.
Table 225
Email Daily Report Commands
COMMAND DESCRIPTION
show daily-report status
Displays the e-mail daily report settings.
daily-report
Enters the sub-command mode for configuring daily e-mail
reports settings.
[no] activate
Turns daily e-mail reports on or off.
draw-usage-graphics
Has the report e-mail include usage graphs.
smtp-address { ip | hostname }
Sets the SMTP mail server IP address or domain name.
[no] smtp-auth activate
Enables or disables SMTP authentication.
smtp-auth username username password password
Sets the username and password for SMTP authentication.
no smtp-address
Resets the SMTP mail server configuration.
no smtp-auth username
Resets the authentication configuration.
[no] smtp-port <1..65535>
Sets the SMTP authentication port. The
no
command deletes
the setting.
mail-subject set subject
Configures the subject of the report e-mails. Spaces are
allowed.
no mail-subject set
Clears the configured subject for the report e-mails.
[no] mail-subject append system-name
Determines whether the system name will be appended to the
subject of the report e-mails.
[no] mail-subject append date-time
Determines whether the sending date-time will be appended
at subject of the report e-mails.
[no] mail-from e_mail
Sets the sender e-mail address of the report e-mails.
[no] mail-to-1 e_mail
Sets to whom the ZyWALL / USG sends the report e-mails (up
to five recipients).
[no] mail-to-2 e_mail
See above.