ZyXEL Communications ZyWall USG 50-H Series, User Manual

Page: 65 / 704

Chapter 4 Wizard Setup
ZyWALL USG 50-H User’s Guide
65
4.4.1 Internet Access Wizard Setup Complete
Well done! You have successfully set up your ZyWALL to access the Internet.
4.5 Wireless Wizard - Configure Wireless Parameters
The wireless wizard configures basic wireless LAN settings so wireless clients can connect to
(or through) the ZyWALL. See
Section 8.10 on page 183 for more on wireless LAN
interfaces.
Click WIRELESS SETUP in the Wizard Setup Welcome screen ( Figure 13 on page 50 ) to
open the following screen. This screen configures the general wireless parameters.
Figure 29 Wireless Wizard: Wireless Parameters
Name : This read-only name identifies the WLAN interface.
SSID : Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
Channel : The ZyWALL automatically scans for and selects an available wireless frequency.
Security : Select the type of wireless security to use for this wireless LAN interface ( WEP ,
WPA-PSK , or WPA2-PSK . WPA2-PSK or WPA-PSK is recommended. Use the other web
configurator screens if you need to configure enterprise WPA.
WEP Encryption : If you selected WEP, select whether to use 64-bit or 128-bit data
encryption.
Key 1 to Key 4 : For 64-bit WEP enter 5 (ASCII) characters or 5 pairs of hexadecimal
characters ("0-9", "A-F") preceded by 0x for each key. For 128-bit WEP, enter 13 (ASCII)
characters or 13 pairs of hexadecimal characters ("0-9", "A-F") preceded by 0x for each key.
The values for the four data encryption keys must be set up exactly the same on the wireless
clients as they are on the ZyWALL.
Pre-Shared Key : For WPA2-PSK or WPA-PSK, type a pre-shared key from 8 to 63 case-
sensitive ASCII characters (including spaces and symbols).