ZyXEL Communications ZyWALL 110 Series, User Manual, Page: 444 / 562

Chapter 37 System
ZyWALL 110/310/1100 Series User’s Guide
444
37.2 Host Name
A host name is the unique name by which a device is known on a network. Click Configuration >
System > Host Name to open the Host Name screen.
Figure 293
Configuration > System > Host Name
The following table describes the labels in this screen.
37.3 USB Storage
The ZyWALL can use a connected USB device to store the system log and other diagnostic
information. Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > System > USB Storage to open the screen as shown next.
Table 174
Configuration > System > Host Name
LABEL DESCRIPTION
System Name Enter a descriptive name to identify your ZyWALL device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Domain Name Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes “-” are accepted.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.