ZyXEL Communications ZyWALL 110 Series, User Manual, Page: 193 / 562

Chapter 9 Policy and Static Routes
ZyWALL 110/310/1100 Series User’s Guide
193
Figure 110
Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)
The following table describes the labels in this screen.
Table 68
Configuration > Network > Routing > Policy Route > Add/Edit
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings Click this button to display a greater or lesser number of configuration fields.
Create new Object Use this to configure any new settings objects that you need to use in this screen.
Configuration
Enable Select this to activate the policy.
Description Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User Select a user name or user group from which the packets are sent.
Incoming Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or
the ZyWALL itself. For an interface, a tunnel, or an SSL VPN, you also need to select
the individual interface, VPN tunnel, or SSL VPN connection.
Source Address Select a source IP address object from which the packets are sent.
Destination Address Select a destination IP address object to which the traffic is being sent. If the next hop
is a dynamic VPN tunnel and you enable Auto Destination Address, the ZyWALL
uses the local network of the peer router that initiated an incoming dynamic IPSec
tunnel as the destination address of the policy instead of your configuration here.