ZyXEL Communications ZyAIR G-3000, User Manual

Page: 167 / 222

ZyAIR G-3000 User’s Guide
Chapter 19 System Maintenance and Information 168
Enter 11, from menu 24, to display Menu 24.11 - Remote Management Control (shown
next)
Figure 108 Menu 24.11 Remote Management Control
The following table describes the fields in this menu.
19.3.5 Remote Management Limitations
Remote management over LAN or WAN will not work when:
Note: If you enable remote management of a service, but have
applied a filter to block the service, then you will not be able to
remotely manage the service.
Menu 24.11 - Remote Management Control
TELNET Server: Port = 23 Access = ALL
Secure Client IP = 0.0.0.0
FTP Server: Port = 21 Access = ALL
Secure Client IP = 0.0.0.0
Web Server: Port = 80 Access = ALL
Secure Client IP = 0.0.0.0
SNMP Service: Port = 161 Access = ALL
Secure Client IP = 0.0.0.0
DNS Service: Port = 53 Access = ALL
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Table 56 Menu 24.11 Remote Management Control
FIELD DESCRIPTION
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service Each of these read-only labels denotes a server or service that you may use to
remotely manage the ZyAIR.
Port This field shows the port number for the remote management service. You may
change the port number for a service if needed, but you must use the same
port number to use that service for remote management.
The DNS Service
port number is 53. This cannot be changed.
Access Select the access interface (if any) by pressing the [SPACE BAR]. Choices are:
LAN only , WAN only , All or Disable . The default is LAN only .
Secured Client IP The default 0.0.0.0 allows any client to use this service to remotely manage the
ZyAIR. Enter an IP address to restrict access to a client with a matching IP
address.
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.