ZyXEL Communications XS3800-28, User Manual, Page: 716 / 789

Chapter 88 Networked AV Mode
XS3800-28 User’s Guide
716
88.22 Port Setup
Use this screen to configure Switch port settings. Click PORT > Port Setup in the navigation panel to
display the configuration screen.
Figure 572 PORT > Port Setup
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
LACP Timeout Timeout is the time interval between the individual port exchanges of LACP packets in order to
check that the peer port in the trunk group is still up. If a port does not respond after three tries,
then it is deemed to be “down” and is removed from the trunk. Set a short timeout (1 second) for
busy trunked links to ensure that disabled ports are removed from the trunk group as soon as
possible.
Select either 1 second or 30 seconds.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 385 PORT > Link Aggregation > Link Aggregation Control Protocol (continued)
LABEL DESCRIPTION