ZyXEL Communications XS3800-28, User Manual, Page: 710 / 789

Chapter 88 Networked AV Mode
XS3800-28 User’s Guide
710
Figure 567 SYSTEM > SNMP > SNMP Trap Port
The following table describes the labels in this screen.
88.17 PORT
The following sections introduce the PORT screens.
Table 382 SYSTEM > SNMP > SNMP Trap Port
LABEL DESCRIPTION
Options Select the trap type you want to configure here.
Port This field displays a port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the trap type of SNMP traps on this port. The Switch sends the
related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.