ZyXEL Communications XS3800-28, User Manual, Page: 66 / 789

Chapter 4 Web Configurator
XS3800-28 User’s Guide
66
Figure 38 Wizard > Basic Settings > Step 2 Password
Note: The input string of any field in this screen should not contain [ ? ], [ | ], [ ' ], [ " ], or [ , ]. In
the Password fields, [ space ] is also not allowed.
Each field is described in the following table.
Table 11 Wizard > Basic Settings > Step 2 Password
LABEL DESCRIPTION
Administrator's Password
Current
password
Enter the existing system password (1234 is the default password when shipped).
New password Enter your new system password. Up to 32 printable ASCII characters are allowed for the
new password.
Confirm
password
Re-enter your new system password for confirmation.
SNMP
SNMP Select Enabled to let the Switch act as an SNMP agent, which allows a manager station to
manage and monitor the Switch through the network. Select Disabled to turn this feature
off.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (
v2c ), SNMP version 3 ( v3 ) or both
( v3v2c ).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNextrequests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or lower.
Set Community Enter the Set Community string, which is the password for the incoming Set- requests from
the management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or lower.