ZyXEL Communications XS3800-28, User Manual, Page: 629 / 789

Chapter 84 ARP Inspection
XS3800-28 User’s Guide
629
Figure 495 SECURITY > IPv6 Source Guard > IP Static Binding > IP Source Binding Status
The following table describes the labels in this screen.
84.9 IPv6 Static Binding
Use this screen to view or configure an IPv6 source guard binding table entry and manage IPv6 static
bindings. Static bindings are uniquely identified by the source IPv6 address / prefix. Each source IPv6
address / prefix can only be in one static binding. If you try to create a static binding with the same
Table 338 SECURITY > IPv6 Source Guard > IP Static Binding > IP Source Binding Status
LABEL DESCRIPTION
Clear Dynamic
Source Binding Specify how you want the Switch to remove dynamic IPv6 source binding entries when you
click
Flush .
• Select All to remove all of the dynamic entries from the IPv6 source binding table.
• Select IPv6 Address and enter an IPv6 address to remove the dynamic entries snooped
with the specified IPv6 address.
• Select IPv6 Prefix and enter a Prefix address to remove the dynamic entries snooped with
the specified Prefix address.
Flush Click this to remove dynamic IPv6 source binding entries according to your selections.
Cancel Click this to reset the values above based or if not applicable, to clear the fields above.
Index This field displays a sequential number for each binding.
Source Address This field displays the source IP address in the binding. If the entry is blank, this field will not be
checked in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies to all
ports.
Lease This field displays how many days, hours, minutes, and seconds the binding is valid; for
example,
2d3h4m5s means the binding is still valid for 2 days, 3 hours, 4 minutes, and 5
seconds. This field displays infinity if the binding is always valid (for example, a static binding).
Type This field displays how the Switch learned the binding.
S : This static binding was learned from information provided manually by an administrator.
DH : This dhcp-snooping binding was learned by snooping DHCP packets.