ZyXEL Communications XS3800-28, User Manual, Page: 574 / 789

Chapter 76 Classifier
XS3800-28 User’s Guide
574
76.5 Classifier Example
The following screen shows an example where you configure a classifier that identifies all traffic from
MAC address 00:50:ba:ad:4f:81 on port 2.
Active Enable the switch button to allow the Switch to create a log when packets match a classifier rule
during a defined time interval.
Interval Set the length of the time period (in seconds) to count matched packets for a classifier rule. Enter an
integer from 0 – 65535. 0 means that no logging is done.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 308 SECURITY > ACL > Classifier > Classifier Global Setting (continued)
LABEL DESCRIPTION