ZyXEL Communications XS3800-28, User Manual, Page: 536 / 789

Chapter 72 VRRP
XS3800-28 User’s Guide
536
72.4 VRRP Configuration Examples
The following sections show two VRRP configuration examples on the Switch.
72.4.1 One Subnet Network Example
The figure below shows a simple VRRP network with only one virtual router VR1 (VRID =1) and two
switches. The network is connected to the WAN through an uplink gateway G (172.16.1.100). The host
computer X is set to use VR1 as the default gateway.
Figure 425 VRRP Configuration Example: One Virtual Router Network
You want to set switch A as the master router. Configure the VRRP parameters in the VRRP Setup screens
on the switches as shown in the figures below.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 289 NETWORKING > VRRP > VRRP Setup: VRRP Parameters > Add/Edit (continued)
LABEL DESCRIPTION