Chapter 67 OSPF
XS3800-28 User’s Guide
508
The following table describes the related labels in this screen.
67.4 IPv4 OSPF Interfaces
To configure an OSPF interface, first create an IP routing domain in the
SYSTEM
>
IP Setup
screen. Once
you create an IP routing domain, an OSPF interface entry is automatically created. See
for more information on OSPF.
Click
NETWORKING
>
OSPF
>
IPv4 OSPF
>
OSPF Interface
to display the following
screen.
Figure 403
NETWORKING > OSPF > IPv4 OSPF > OSPF Interface
Table 268 NETWORKING > OSPF > IPv4 OSPF > OSPF Setup: Area Setup > Add/Edit
LABEL
DESCRIPTION
Name
Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ])
for identification purposes.
Area ID
Enter a 32-bit ID (that uses the format of an IP address in dotted decimal notation) that uniquely
identifies an area.
A value of
0.0.0.0
indicates that this is a backbone (also known as Area 0). You can create only
one backbone area on the Switch.
Authentication
Select an authentication method (
Simple
or
MD5
) to activate authentication. Select
None
(default)
to disable authentication.
Usually interfaces and virtual interfaces should use the same authentication method as the
associated area. If interfaces and virtual interfaces use different authentication methods than
the associated area, the authentication methods are based on the interfaces and virtual
interfaces settings.
Stub/NSSA
Select
Stub
to set the area as a stub area; Select
NSSA
to set the area as a not-so-stubby area.
Select
None
if you do not want to define the area as a
Stub/NSSA
area.
If you enter
0.0.0.0
in the
Area ID
field, the settings in the stub area fields are ignored.
No Summary Select this option to set the Switch to not send or receive LSAs.
Default
route cost
Specify a cost (between 0 and 16777215) used to add a default route into a stub area for routes
which are external to an OSPF domain. If you do not set a route cost, no default route is added.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
Summary of Contents for XS3800-28
