ZyXEL Communications XS3800-28, User Manual, Page: 499 / 789

Chapter 66 IGMP
XS3800-28 User’s Guide
499
Figure 396 NETWORKING > Loopback Interface > IPv4 Loopback Interface
The following table describes the labels in this screen.
66.5.1 Add/Edit IPv4 Loopback Interface
Use this screen to configure IPv4 loopback interfaces on the Switch. Click Add/Edit , or select an entry
and click Add/Edit in the NETWORKING > Loopback Interface > IPv4 Loopback Interface screen to
display the screen.
Figure 397 NETWORKING > Loopback Interface > IPv4 Loopback Interface > Add/Edit
The following table describes the labels in this screen.
Table 261 NETWORKING > Loopback Interface > IPv4 Loopback Interface
LABEL DESCRIPTION
ID This field displays the identification number of the interface.
Active This field displays whether the IPv4 loopback interface is activated or not.
Name This field displays the descriptive name for this IPv4 loopback interface.
IP Address This field displays the IP address of the Switch in the IP domain.
IP Subnet Mask This field displays the subnet mask of the Switch in the IP domain.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 262 NETWORKING > Loopback Interface > IPv4 Loopback Interface > Add/Edit
LABEL DESCRIPTION
Loopback
Interface ID Select the ID of loopback interface you want to configure.
Active Enable the switch button to enable the interface.
Name Enter a descriptive name for the IPv4 loopback interface for identification purposes. This name
consists of up to 64 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ], or [ , ]; spaces are
allowed.