ZyXEL Communications XS3800-28, User Manual, Page: 425 / 789

Chapter 57 VLAN
XS3800-28 User’s Guide
425
Figure 320 SWITCHING > VLAN > VLAN Setup > GVRP (Stacking Mode)
The following table describes the labels in this screen.
57.8 Subnet Based VLANs
Subnet based VLANs allow you to group traffic into logical VLANs based on the source IP subnet you
specify. When a frame is received on a port, the Switch checks if a tag is added already and the IP
Table 205 SWITCHING > VLAN > VLAN Setup > GVRP
LABEL DESCRIPTION
GVRP GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network.
Enable the switch button to permit VLAN groups beyond the local Switch.
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port This field displays the port number of the Switch. In Stacking mode, the first number represents
the slot ID and the second is the port number. Please note that the default stacking ports (the
last four ports of your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
GVRP Select this check box to allow GVRP on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.