ZyXEL Communications XS3800-28, User Manual, Page: 383 / 789

Chapter 54 Spanning Tree Protocol
XS3800-28 User’s Guide
383
Figure 285 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status: RSTP (Stacking Mode)
The following table describes the labels in this screen.
Table 186 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status: RSTP
LABEL DESCRIPTION
Bridge Root Bridge refers to the base of the spanning tree (the root bridge). Our Bridge is this Switch.
This Switch may also be the root bridge.
Bridge ID This is the unique identifier for this bridge, consisting of bridge priority plus MAC address. This ID
is the same for
Root Bridge and Our Bridge if the Switch is the root switch.
Hello Time
(seconds) This is the time interval (in seconds) at which the root switch transmits a configuration
message. The root bridge determines
Hello Time , Max Age and Forwarding Delay .
Max Age
(seconds) This is the maximum time (in seconds) the Switch can wait without receiving a configuration
message before attempting to reconfigure.
Forwarding Delay
(seconds) This is the time (in seconds) the root switch will wait before changing states (that is, listening to
learning to forwarding).
Note: The listening state does NOT exist in RSTP.
Cost to Bridge This is the path cost from the root port on this Switch to the root switch.
Port ID This is the priority and number of the port on the Switch through which this Switch must
communicate with the root of the Spanning Tree.
Topology
Changed Times This is the number of times the spanning tree has been reconfigured.
Time Since Last
Change This is the time since the spanning tree was last reconfigured.