ZyXEL Communications XS3800-28, User Manual, Page: 374 / 789

Chapter 53 sFlow
XS3800-28 User’s Guide
374
The following table describes the labels in this screen.
53.3.1 Add/Edit sFlow Collector
Click Add/Edit , or select an entry and click Add/Edit in the SWITHCING > sFlow > Collector screen to
display this screen.
Figure 279 SWITCHING > sFlow > Collector > Add/Edit
The following table describes the labels in this screen.
Table 178 SWITHCING > sFlow > Collector
LABEL DESCRIPTION
Index This field displays the index number of this entry.
Collector
Address This field displays IP address of the sFlow collector.
UDP Port This field displays port number the Switch uses to send sFlow datagram to the collector.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 179 SWITCHING > sFlow > Collector > Add/Edit
LABEL DESCRIPTION
Collector
Address Enter the IP address of the sFlow collector.
UDP Port Enter a UDP port number the Switch uses to send sFlow datagram to the collector. If you change
the port here, make sure you change it on the collector, too. The default port is 6343.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.