Chapter 44 Multicast
XS3800-28 User’s Guide
327
44.11.2 Add MLD Snooping-proxy Filtering Rule
Use this screen to create a multicast addresses range rule of the MLD filtering profile.
Click
Add Rule
in the
SWITCHING
>
Multicast
>
IPv6 Multicast
>
Filtering Profile
to display this screen.
Figure 239
SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
The following table describes the fields in the above screen.
44.12 General MVR Configuration
Use this screen to view and create multicast VLANs.
End Address
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the
Start Address
and
End
Address
fields.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
Table 147 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile (continued)
LABEL
DESCRIPTION
Table 148 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
LABEL
DESCRIPTION
Profile Name
Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
End Address
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the
Start Address
and
End
Address
fields.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
Summary of Contents for XS3800-28
