ZyXEL Communications XS3800-28, User Manual, Page: 217 / 789

Chapter 32 Flex Link
XS3800-28 User’s Guide
217
The following table describes the labels in this screen.
32.3 Flex Link Setup
Click PORT > Flex Link > Flex Link Setup to display this screen.
Note: The Flex Link ( PORT > Flex Link ), STP ( SWITCHING > Spanning Tree Protocol ), Loop Guard
( SWITCHING > Loop Guard ) and Link Aggregation ( PORT > Link Aggregation ) features
cannot be configured together on the same port. When one of the above functions is
enabled, the Switch will not let you enable the others.
Note: You can configure up to five pairs of flex links.
Figure 146 PORT > Flex Link > Flex Link Setup
The following table describes the labels in this screen.
Table 91 PORT > Flex Link > Flex Link Status
LABEL DESCRIPTION
Index This displays the index number of a flex link pair.
Primary Port This displays the port number of the primary link.
In Stacking mode, the first number represents the slot ID and the second is the port number.
Backup Port This displays the port number of the backup link.
In Stacking mode, the first number represents the slot ID and the second is the port number.
State This displays the link status of the Primary port and Backup port.
Down – The link is down.
Up – The link is up and the port state is FORWARDING.
Standby – The link is up and the port state is BLOCKING.
Note: Only one port can be up in a flex link pair.
Table 92 PORT > Flex Link > Flex Link Setup
LABEL DESCRIPTION
Index This displays the index number of an entry.
Primary Port This displays the port number of the primary link.
In Stacking mode, the first number represents the slot ID and the second is the port number.
Backup Port This displays the port number of the backup link.
In Stacking mode, the first number represents the slot ID and the second is the port number.