ZyXEL Communications XS3800-28, User Manual, Page: 211 / 789

Chapter 29 Syslog Setup
XS3800-28 User’s Guide
211
29.2.1 Add/Edit a Syslog Server
Use this screen to configure an external syslog server.
Click Add/Edit , or select an entry and click Add/Edit in the SYSTEM > Syslog Setup screen to display this
screen.
Figure 142 SYSTEM > Syslog Setup > Add/Edit
The following table describes the labels in this screen.
Table 88 SYSTEM > Syslog Setup > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to have the device send logs to this syslog server. Clear the check
box if you want to create a syslog server entry but not have the device send logs to it (you
can edit the entry later).
Server Address Enter the IPv4 or IPv6 address of the syslog server.
UDP Port The default syslog server port is 514. If your syslog server uses a different port, configure the
one it uses here.
Log Level Select the severity levels of the logs that you want the device to send to this syslog server.
The lower the number, the more critical the logs are.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.