ZyXEL Communications XS3800-28, User Manual, Page: 156 / 789

Chapter 22 Interface Setup
XS3800-28 User’s Guide
156
22.2.1 Add/Edit Interfaces
Click Add/Edit , or select an entry and click Add/Edit in the SYSTEM > Interface Setup screen to display
the configuration screen.
Figure 99 SYSTEM > Interface Setup > Add/Edit
The following table describes the labels in this screen.
Add/Edit Click Add/Edit to add a new interface or edit a selected one.
Delete Click Delete to remove the selected interfaces.
Table 42 SYSTEM > Interface Setup (continued)
LABEL DESCRIPTION
Table 43 SYSTEM > Interface Setup > Add/Edit
LABEL DESCRIPTION
Interface Type Select the type of interface you want to create. At the time of writing, the Switch supports the
following interface types:
• VLAN interface for IPv6
• IPv4 loopback interface.
Interface ID Specify a unique identification number (from 1 to 4094) for the VLAN interface or a unique
identification number (from 0 to 2) for the loopback interface.
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
SWITCHING > VLAN screens.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.