ZyXEL Communications XS3800-28, User Manual, Page: 100 / 789

Chapter 6 Tutorials
XS3800-28 User’s Guide
100
6
Clear the Tx Tagging check box to set the Switch to remove VLAN tags before sending.
7
Click Apply to save the settings to the run-time memory. Settings in the run-time memory are lost when
the Switch’s power is turned off.
8
Go to VLAN > VLAN Setup > VLAN Port Setup . Enter “102” in the PVID field for port 2 to add a tag to
incoming untagged frames received on that port so that the frames are forwarded to the VLAN group
that the tag defines.
9
Click Apply to save your changes back to the run-time memory.
10
Click the Save link in the upper right of the Web Configurator to save your configuration permanently.
6.3.3 Configure DHCPv4 Relay
Follow the steps below to enable DHCP relay on the Switch and allow the Switch to add relay agent
information (such as the VLAN ID) to DHCP requests.
1
Click NETWORKING > DHCP > DHCPv4 Relay > DHCP Smart Relay . Enable the Active switch button.