ZyXEL Communications XS1920 Series, User Manual

Page: 311 / 422

Chapter 35 Static Route
XS1920 Series User’s Guide
311
35.4 IPv6 Static Route
Click the link next to IPv6 Static Route in the IP Application > Static Routing screen to display
the screen as shown.
Figure 214
IP Application > Static Routing > IPv6 Static Route
The following table describes the related labels you use to create a static route.
Metric This field displays the cost of transmission for routing purposes.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 154
IP Application > Static Routing > IPv4 Static Route (continued)
LABEL DESCRIPTION
Table 155
IP Application > Static Routing > IPv6 Static Route
LABEL DESCRIPTION
Route
Destination Enter the IPv6 address of the final destination.
Prefix Length Enter the prefix length number of up to 64 for this destination.
Next Hop Enter the IPv6 address of the next-hop router.
Interface Type Select the type of the IPv6 interface through which the IPv6 packets are forwarded.
The Switch supports only the VLAN interface type at the time of writing.
Interface ID Enter the ID number of the IPv6 interface through which the IPv6 packets are forwarded.
Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This field displays the index number of the route. Click a number to edit the static route
entry.