ZyXEL Communications XS1920 Series, User Manual

Page: 242 / 422

Chapter 26 IP Source Guard
XS1920 Series User’s Guide
242
26.9 IPv6 Static Binding Setup
Use this screen to manually create an IPv6 source guard binding table entry and manage IPv6
static bindings. Static bindings are uniquely identified by the source IPv6 address / prefix. Each
source IPv6 address / prefix can only be in one static binding. If you try to create a static binding
with the same source IPv6 address / prefix as an existing static binding, the new static binding
replaces the original one. To open this screen, click
Advanced Application > IP Source Guard >
IPv6 Static Binding Setup .
Figure 164
Advanced Application > IP Source Guard > IPv6 Static Binding Setup
Source Address This field displays the source IP address in the binding. If the entry is blank, this field will
not be checked in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field
will not be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will
not be checked in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies
to all ports.
Lease This field displays how many days, hours, minutes, and seconds the binding is valid; for
example,
2d3h4m5s means the binding is still valid for 2 days, 3 hours, 4 minutes, and
5 seconds. This field displays infinity if the binding is always valid (for example, a static
binding).
Type This field displays how the Switch learned the binding.
S : This static binding was learned from information provided manually by an
administrator.
DH : This dhcp-snooping binding was learned by snooping DHCP packets.
Table 114
Advanced Application > IP Source Guard > IPv6 Source Binding Status (continued)
LABEL DESCRIPTION