Chapter 59 VLAN Stacking
XGS2220 Series User’s Guide
403
59.6.1 Add/Edit Selective Q-in-Q
Click
Add/Edit
, or select an entry and click
Add/Edit
in the
SWITCHING
>
VLAN Stacking
>
Selective QinQ
screen to display this screen.
Figure 300
SWITCHING > VLAN Stacking > Selective QinQ > Add/Edit
The following table describes the labels in this screen.
SPVID
This is the service provider’s VLAN ID that adds to the packets from the subscribers.
Priority
This is the service provider’s priority level in the packets.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Add/Edit
Click
Add/Edit
to add a new entry or edit a selected one.
Delete
Click
Delete
to remove the selected entries.
Table 224 SWITCHING > VLAN Stacking > Selective QinQ (continued)
LABEL
DESCRIPTION
Table 225 SWITCHING > VLAN Stacking > Selective QinQ > Add/Edit
LABEL
DESCRIPTION
Active
Enable the switch button to activate this rule.
Name
Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) for
identification purposes.
Port
The port number identifies the port you are configuring.
CVID
Enter a customer VLAN ID (the inner VLAN tag) from 1 to 4094. This is the VLAN tag carried in the
packets from the subscribers.
SPVID
SPVID
is the service provider’s VLAN ID (the outer VLAN tag). Enter the service provider ID (from 1 to
4094) for frames received on this port.
Priority
Select a priority level (from 0 to 7). This is the service provider’s priority level that adds to the frames
received on this port.
"0" is the lowest priority level and "7" is the highest.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the
Save
link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
