Chapter 45 Multicast
XGS2220 Series User’s Guide
294
Figure 209
SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile > Add Rule
The following table describes the labels in this screen.
45.6 IPv6 Multicast Status
Click
SWITCHING
>
Multicast
>
IPv6 Multicast
>
IPv6 Multicast Status
to display the screen as shown. This
screen shows the IPv6 multicast group information. See
for more information
on multicasting.
Figure 210
SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status
The following table describes the fields in the above screen.
Table 142 SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile > Add Rule
LABEL
DESCRIPTION
Profile Name
Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address
Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
End Address
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the
Start
Address
and
End Address
fields.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
Table 143 SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status
LABEL
DESCRIPTION
Index
This is the index number of the entry.
VID
This field displays the multicast VLAN ID.
Port
This field displays the port number that belongs to the multicast group.
