Chapter 35 Link Layer Discovery Protocol (LLDP)
XGS2220 Series User’s Guide
243
The following table describes the labels in this screen.
35.9 LLDP-MED Network Policy
Click
PORT
>
LLDP
>
LLDP MED
>
LLDP-MED Network Policy
to display the screen as shown next.
Figure 174
PORT > LLDP > LLDP MED > LLDP-MED Network Policy
The following table describes the labels in this screen.
Table 116 PORT > LLDP > LLDP > LLDP-MED Setup
LABEL
DESCRIPTION
Port
This displays the Switch’s port number. Select * to configure all ports simultaneously.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location
Select to enable transmitting LLDP-MED location TLV.
Network Policy
Select to enable transmitting LLDP-MED Network Policy TLV.
Apply
Click
Apply
to save the changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 117 PORT > LLDP > LLDP MED > LLDP-MED Network Policy
LABEL
DESCRIPTION
Index
This field displays the of index number of the network policy. Click an index number to edit
the rule.
Port
This field displays the port number of the network policy.
Application Type
This field displays the application type of the network policy.
Tag
This field displays the Tag Status of the network policy.
VLAN
This field displays the VLAN ID of the network policy.
DSCP
This field displays the DSCP value of the network policy.
Priority
This field displays the priority value of the network policy.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
