Chapter 36 Access Control
XGS1930 Series User’s Guide
291
36.3.2 Enabling/Disabling Sending of SNMP Traps on a Port
From the
SNMP > Trap Group
screen, click
Port
to view the screen as shown. Use this screen to set
whether a trap received on the port(s) would be sent to the SNMP manager.
Figure 209
Management > Access Control > SNMP > Trap Group > Port
The following table describes the labels in this screen.
Options
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category’s check box automatically clears all of the
category’s trap check boxes (the Switch only sends traps from selected categories).
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 148 Management > Access Control > SNMP > Trap Group (continued) (continued)
LABEL
DESCRIPTION
Table 149 Management > Access Control > SNMP > Trap Group > Port
LABEL
DESCRIPTION
Option
Select the trap type you want to configure here.
Port
This field displays a port number.
