Chapter 47 Configure Clone
XGS1930 Series User’s Guide
347
Figure 257
Management > Configure Clone
The following table describes the labels in this screen.
Table 182 Management > Configure Clone
LABEL
DESCRIPTION
Source/
Destination
Port
Enter the source port under the
Source
label. This port’s attributes are copied.
Enter the destination port or ports under the
Destination
label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
2, 4, 6
indicates that ports 2, 4 and 6 are the destination ports.
2–6
indicates that ports 2 through 6 are the destination ports.
*
Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Basic Setting
Select which port settings (you configured in the
Basic Setting
menus) should be copied to the
destination ports.
Advanced
Application
Select which port settings (you configured in the
Advanced Application
menus) should be copied
to the destination ports.
Summary of Contents for XGS1930-28HP
Page 19: ...19 PART I User s Guide...
Page 39: ...39 PART II Technical Reference...
