ZyXEL Communications XGS-4528F, User Manual, Page: 394 / 491

Chapter 45 Maintenance
XGS-4526/4528F/4728F User’s Guide
394
ZyNOS (ZyXEL Network Operating System, sometimes referred to as the “ras” file)
is the system firmware and has a “bin” filename extension.
45.8.1.1 Example FTP Commands
ftp> put firmware.bin ras
This is a sample FTP session showing the transfer of the computer file
"firmware.bin" to the Switch.
ftp> get config config.cfg
This is a sample FTP session saving the current configuration to a file called
“config.cfg” on your computer.
If your (T)FTP client does not allow you to have a destination filename different
than the source, you will need to rename them as the Switch only recognizes
“config” and “ras”. Be sure you keep unaltered copies of both files for later use.
Be sure to upload the correct model firmware as uploading the
wrong model firmware may damage your device.
45.8.2 FTP Command Line Procedure
1
Launch the FTP client on your computer.
2
Enter
open
, followed by a space and the IP address of your Switch.
3
Press
[ENTER]
when prompted for a username (the default is “admin”).
4
Enter your password as requested (the default is “1234”).
5
Enter
bin
to set transfer mode to binary.
Table 142 Filename Conventions
FILE TYPE
INTERNA
L NAME EXTERNA
L NAME
DESCRIPTION
Configuration
File config .cfg This is the configuration (config) filename on
the Switch. Uploading the config file replaces
the specified configuration file system,
including your Switch configurations, system-
related data (including the default password),
the error log and the trace log.
Firmware ras *.bin This is the generic name for the ZyNOS
firmware on the Switch.