ZyXEL Communications X2002, User Manual

Page: 366 / 562

Chapter 24 System Information
X2002 User’s Guide
366
24.3.3 Configuring SNMP
To change your X2002’s SNMP settings, click Monitor > SNMP tab. The screen
appears as shown. Use this screen to configure your SNMP settings.
Figure 220 Monitor > SNMP
The following table describes the labels in this screen.
Table 139 Monitor > SNMP
LABEL DESCRIPTION
Enable Select or clear the check box to enable or disable SNMP service.
Get
Community Enter the password for the incoming Get and GetNext requests from the
management station. The default is ”public” and allows all requests.
Set
Community Enter the password for incoming Set requests from the management
station. The default is “private” and allows all requests.
SNMP Port You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Community Type the trap community, which is the password sent with each trap to
the SNMP manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
Trap Port You may change the port number the X2002 uses for sending traps to the
SNMP manager if needed.
Apply Click Apply to save your changes back to the X2002.
Reset Click Reset to return the screen to its last-saved settings.