Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
57
The following table describes the labels in this screen.
9.6 AP Select Screen
Use this screen (available in repeater mode only) to choose an access point that you want the
WRE6505 v2 to connect to. You should know the security settings of the target AP.
To open this screen, click
Network
>
Wireless LAN 2.4G
or
Wireless LAN 5G
>
AP Select
.
Figure 34
Network > Wireless LAN 2.4G/5G > AP Select (Repeater Mode)
Table 18
Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL
DESCRIPTION
Security Mode
Select
WPA-PSK
or
WPA2-PSK
to enable data encryption.
WPA-PSK
Compatible
This field appears when you choose
WPA2-PSK
as the
Security Mode
.
Check this field to allow wireless devices using
WPA-PSK
security mode to connect to
your WRE6505 v2.
Pre-Shared Key
WPA-PSK/WPA2-PSK
uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The
Group Key Update Timer
is the rate at which the AP sends a new group key out to
all clients.
The default is
3600
seconds (60 minutes).
Apply
Click
Apply
to save your changes back to the WRE6505 v2.
Reset
Click
Reset
to reload the previous configuration for this screen.
