ZyXEL Communications WAP5805, User Manual

Page: 66 / 125

Chapter 10 Maintenance
WAP5805 User’s Guide
66
The following table describes the labels in this screen.
10.4 Password Screen
It is strongly recommended that you change your WAP5805's password.
If you forget your WAP5805's password (or IP address), you will need to reset the device. See
Section 10.9 on page 71 for details
Click Maintenance > Password .
Figure 44
Maintenance > Password
The following table describes the labels in this screen.
Table 29
Maintenance > General
LABEL DESCRIPTION
Administrator
Inactivity Timer Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Apply Click Apply to save your changes back to the WAP5805.
Cancel Click Cancel to discard the changes.
Table 30
Maintenance > Password
LABEL DESCRIPTION
Password Setup Change your WAP5805’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the system in
this field.
New Password Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the WAP5805.
Cancel Click Cancel to discard the changes.