ZyXEL Communications WAP5705, User Manual

Page: 92 / 156

Chapter 11 Maintenance
WAP5705 User’s Guide
92
The following table describes the labels in this screen.
11.4 Password Screen
It is strongly recommended that you change your WAP5705's password.
If you forget your WAP5705's password (or IP address), you will need to reset the device. See
Section 11.8 on page 97 for details
Click Maintenance > Password .
Figure 62
Maintenance > Password
The following table describes the labels in this screen.
Table 40
Maintenance > General
LABEL DESCRIPTION
Administrator
Inactivity Timer Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Apply Click Apply to save your changes back to the WAP5705.
Reset Click Reset to begin configuring this screen afresh.
Table 41
Maintenance > Password
LABEL DESCRIPTION
Password Setup Change your WAP5705’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the system in
this field.
New Password Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the WAP5705.
Reset Click Reset to begin configuring this screen afresh.