ZyXEL Communications WAP5705, User Manual

Page: 84 / 156

Chapter 9 Wireless LAN
WAP5705 User’s Guide
84
9.10 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar button in
the wireless station utility within 2 minutes. To add the second wireless station, you
have to press these buttons on both device and the wireless station again after the
first 2 minutes.
Figure 55
Network > Wireless LAN > WPS Station
Status This displays Configured when the WAP5705 has connected to a wireless network using
WPS or when Enable WPS is selected and wireless or wireless security settings have
been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless
security changes on the WAP5705 or you click Release_Configuration to remove the
configured wireless and wireless security settings.
Release
Configuration This button is only available when the WPS status displays Configured .
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the WAP5705.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the
WAP5705.
SSID This is the name of the wireless network (the WAP5705’s first SSID).
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the WAP5705.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 35
Network > Wireless LAN > WPS
LABEL DESCRIPTION