ZyXEL Communications WAP5705, User Manual

Page: 77 / 156

Chapter 9 Wireless LAN
WAP5705 User’s Guide
77
9.5 Wireless Security Screen
Use this screen to select the wireless security mode for each SSID. Click Network > Wireless LAN
> Security to open the Security screen. The screen varies depending on what you select in the
Security Mode field.
9.5.1 No Security
Select No Security to allow wireless clients to communicate with the access points without any
data encryption.
Note: If you do not enable any wireless security on your WAP5705, your network is
accessible to any wireless networking device that is within range.
Figure 48
Network > Wireless LAN > Security: No Security
The following table describes the labels in this screen.
Channel
Selection Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the frequency
band and the country you are in.
This option is only available if Auto Channel Selection is disabled.
Auto
Channel
Selection
Select the check box to have the WAP5705 automatically scan for and select a channel
which is not used by another device.
Operating
Channel This displays the channel the WAP5705 is currently using.
Apply Click Apply to save your changes back to the WAP5705.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 28
Network > Wireless LAN > General
LABEL DESCRIPTION
Table 29
Network > Wireless LAN > Security: No Security
LABEL DESCRIPTION
SSID Select the SSID for which you want to configure the security.
Security Mode Choose No Security from the drop-down list box.
Apply Click Apply to save your changes back to the WAP5705.
Cancel Click Cancel to reload the previous configuration for this screen.