ZyXEL Communications WAP5705, User Manual

Page: 44 / 156

Chapter 5 Client Mode
WAP5705 User’s Guide
44
5.8 WPS Screen
Use this screen to enable Wi-Fi Protected Setup (WPS) on the WAP5705. Go to Configuration >
Wireless LAN > WPS to open the following screen.
Figure 29
Client Mode: WLAN > WPS
The following table describes the labels in this screen.
Rescan Click this button to search for available wireless devices within transmission range and
update this table.
Add Profile Select a wireless device and click this button to add it to a profile.
Table 17
Client Mode: WLAN > Site Survey (continued)
LABEL DESCRIPTION
Table 18
Client Mode: WLAN > WPS
LABEL DESCRIPTION
Station Site Survey
No. Use the radio button to select the wireless device to which you want to connect using WPS.
SSID This displays the SSID of the wireless device.
BSSID This displays the MAC address of the wireless device.
Signal Strength This displays the strength of the wireless signal. The signal strength mainly depends on the
antenna output power and the distance between your WAP5705 and this device.
Ch. This displays the channel number used by this wireless device.
Auth. This displays the authentication method used by this wireless device.
Encrypt This displays the data encryption method used by this wireless device.
Ver. This displays the firmware version running on the wireless device.
Status This displays Conf. (configured) when WPS has been set up on the wireless device.
This displays Unconf. (unconfigured) if WPS has not been set up on the wireless device.
PIN This displays the PIN number of the WAP5705.
PIN Start Click this button to perform wireless security information synchronization using the PIN
configuration method.
PBC Start Click this button to perform wireless security information synchronization using the Push
Button Configuration (PBC) method.
Rescan Click this button to search for available for WPS-enabled devices within transmission range
and update this table.