ZyXEL Communications WAP5705, User Manual

Page: 43 / 156

Chapter 5 Client Mode
WAP5705 User’s Guide
43
5.7 Site Survey Screen
Use this screen to scan for and connect to a wireless network automatically. Go to Configuration >
Wireless LAN > Site Survey to open the following screen.
Figure 28
Client Mode: WLAN > Site Survey
The following table describes the labels in this screen.
Security
Security Mode Select WPA-PSK or WPA2-PSK to add strong security on this wireless network.
Encryption Type Select the type of wireless encryption employed by the access point to which you want to
connect.
Pre-Shared Key WPA-PSK or WPA2-PSK uses a simple common password for authentication.
Type the pre-shared key employed by the access point to which you want to connect.
Apply Click Apply to save your changes back to the WAP5705.
Back Click Back to go back to the previous screen.
Table 16
Client Mode: WLAN > Profile: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Table 17
Client Mode: WLAN > Site Survey
LABEL DESCRIPTION
Station Site Survey
# Select a wireless device and click Add Profile to open a configuration screen where you
can add the selected wireless device to a profile and then enable it.
SSID This displays the SSID of the wireless device.
indicates the wireless device is added to an activated profile and the WAP5705 is
connecting to it.
BSSID This displays the MAC address of the wireless device.
Signal Strength This displays the strength of the wireless signal. The signal strength mainly depends on the
antenna output power and the distance between your WAP5705 and this device.
Channel This displays the channel number used by this wireless device.
Encryption This displays the data encryption method used by this wireless device.
Authentication This displays the authentication method used by this wireless device.
Network Type This displays the network type ( Infrastructure or Ad Hoc ) of this wireless device.