ZyXEL Communications WAP5705, User Manual

Page: 25 / 156

Chapter 3 Easy Mode
WAP5705 User’s Guide
25
3.6.1 Wireless Security
Use this screen to configure security for your the wreless LAN. You can enter the SSID and select
the wireless security mode in the following screen.
Note: Wireless Security in the control panel is not configurable when the WAP5705 is in
client mode.
Figure 14
Wireless Security
The following table describes the general wireless LAN labels in this screen.
Table 5
Wireless Security
LABEL DESCRIPTION
Wireless
Network Name
(SSID) (Service Set IDentity) The SSID identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
The default SSID is “ZyXEL+(the last six characters of the WAP5705’s MAC address)”.
Security mode Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings as
this device. After you select to use a security, additional options appears in this screen.
Select No Security to allow any client to connect to this network without authentication.
Wireless
password This field appears when you choose wither WPA-PSK or WPA2-PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Verify
password Type the password again to confirm.
Apply Click Apply to save your changes back to the WAP5705.