ZyXEL Communications WAP5705, User Manual

Page: 13 / 156

Chapter 1 Getting to Know Your WAP5705
WAP5705 User’s Guide
13
1.5 Resetting the WAP5705
If you forget your password or IP address, or you cannot access the Web Configurator, you will need
to use the
RESET button at the back of the WAP5705 to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously saved, the password
will be reset to “1234” and the IP address of the WAP5705 in AP mode will be reset to
“192.168.1.2” and the IP address of the WAP5705 in client mode will be reset to “192.168.1.10”.
1.5.1 Procedure to Use the Reset Button
1
Make sure the power LED is on.
2
Press the RESET button for longer than 1 second to restart/reboot the WAP5705.
3
Press the RESET button for longer than five seconds to set the WAP5705 back to its factory-default
configurations.
1.6 The WPS Button
You can use the WPS button ( ) on the front panel of the WAP5705 to activate WPS in order to
quickly set up a wireless network with strong security.
1
Make sure the POWER LED is on (not blinking).
2
Press the WPS button for more than three seconds and release it. Press the WPS button on another
WPS-enabled device within range of the WAP5705.
Note: You must activate WPS in the WAP5705 that acts as the AP and in another
WAP5705 that acts as the client within two minutes of each other.