ZyXEL Communications wap3205 V3, User Manual

Page: 11 / 165

Chapter 1 Introduction
WAP3205 v3 User’s Guide
11
1.3 LEDs
Figure 2 Front Panel
The following table describes the LEDs and the WPS button.
1.4 The WPS/RESET Button
Your WAP3205 v3 supports WiFi Protected Setup (WPS), which is an easy way to set up a secure wireless
network. WPS is an industry standard specification, defined by the Wi-Fi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Each WPS connection works between two devices. Both devices must
support WPS (check each device’s documentation to make sure).
Table 1 Front Panel LEDs and WPS Button
LED COLOR STATUS DESCRIPTION
POWER Green On The WAP3205 v3 is receiving power and functioning properly.
Off The WAP3205 v3 is not receiving power.
WLAN 2.4G Green On The WAP3205 v3 is ready, but is not sending/receiving data through the
wireless LAN.
Blinking The WAP3205 v3 is sending/receiving data through the wireless LAN.
The WAP3205 v3 is negotiating a WPS connection with a wireless client.
Off The wireless LAN is not ready or has failed.
Ethernet Green On The WAP3205 v3 LAN port (any of 5 ports) is connected with a router or
client device.
Off The WAP3205 v3 LAN port (any of 5 ports) is not connected with a
router or client device.
WPS Green On WPS status is configured.
Blinking The WAP3205 v3 is negotiating a WPS connection with a wireless client.
Off The WPS status is not configured or disabled.