ZyXEL Communications VMG5313-B10A, User Manual

Page: 123 / 398

Chapter 7 Wireless
VMG5313-B10A/-B30A Series User’s Guide
123
Figure 39
Network Setting > Wireless > Others
The following table describes the labels in this screen.
Table 27
Network Setting > Wireless > Others
LABEL DESCRIPTION
RTS/CTS
Threshold Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS
(Clear To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold This is the maximum data fragment size that can be sent. Enter a value between 256 and
2346.
Auto Channel
Timer If you set the channel to Auto in the Network Setting > Wireless > General screen,
specify the interval in minutes for how often the VMG scans for the best channel. Enter 0 to
disable the periodical scan.
Output Power Set the output power of the VMG. If there is a high density of APs in an area, decrease the
output power to reduce interference with other APs. Select one of the following:
20% ,
40% , 60% , 80% or 100% .
Beacon Interval When a wirelessly networked device sends a beacon, it includes with it a beacon interval.
This specifies the time period before the device sends the beacon again.
The interval tells receiving devices on the network how long they can wait in low power
mode before waking up to handle the beacon. This value can be set from 50ms to 1000ms.
A high value helps save current consumption of the access point.
DTIM Interval Delivery Traffic Indication Message (DTIM) is the time period after which broadcast and
multicast packets are transmitted to mobile clients in the Power Saving mode. A high DTIM
value can cause clients to lose connectivity with the network. This value can be set from 1
to 255.