ZyXEL Communications VES-1616F-44, User Manual

Page: 260 / 296

VES-1616F/1624F-44 User’s Guide
Chapter 34 IEEE 802.1Q Tagged VLAN Commands 259
C
H A P T E R
34
IEEE 802.1Q Tagged VLAN
Commands
This chapter describes the IEEE 802.1Q Tagged VLAN and associated commands.
34.1 Configuring Tagged VLAN
Refer to Chapter 7 on page 79 for background information on VLANs.
The following procedure shows you how to configure tagged VLAN.
1
Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the
vlan <vlan-id>
command to configure or create a VLAN on the switch. The
switch automatically enters the
config-vlan
mode.Use the
inactive
command to
deactivate the VLAN(s).
• Use the
interface port-channel <port-list> command
to enter the config-
interface mode to set the VLAN settings on a port, then use the
pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the
PVID table.
• Use the
exit
command when you are finished configuring the VLAN.
Example:
2
Configure your management VLAN.
• Use the
vlan <vlan-id>
command to create a VLAN (VID 3 in this example) for
managing the switch, and the switch will activate the new management VLAN.
• Use the
inactive
command to disable the new management VLAN.
sysname(config)# vlan 2000
sysname(config-vlan)# name up1
sysname(config-vlan)# fixed 10-12
sysname(config-vlan)# no untagged 10-12
sysname(config-vlan)# exit
sysname(config)# interface port-channel 10-12
sysname(config-interface)# pvid 2000
sysname(config-interface)# exit